Filter
Top Products
18
Adjusting your Hopper Lid Latches
The seals around the top of the pellet hopper are important to safe and efficient operation of the
unit. The latches installed on these units are designed to pull the hopper lid tight against this seal.
Over the course of operation as these seals “wear in” and compress, the tension of the latches
should be tested periodically, and adjusted if necessary.
To adjust the lid latches, the following tools will be needed; two ½ inch wrenches, or a ½ inch
wrench and a ½ inch socket.
In order to adjust the latch, first open the hopper lid and then lock the latch in its closed position.
Then take the ½ inch wrench and loosen the nut closest to the latch. This nut is then adjusted
closer to the lid itself to tighten the latch. After adjusting this nut to the desired location, hold this nut
in place with the ½ inch wrench, the tighten down the holding nut on the end of the latch shaft with
the ½ inch socket or second wrench to hold the latching assembly in place
After tightening the latches, test the latches for proper tension by locking the lid down and lifting
each front corner of the lid. The lid should be firmly held down by the latches. Repeat the same
procedure if the latch is still not tight enough.
Important: Hopper Lid Latches must be checked periodically and
kept tight so the top is sealed to prevent back-burn.
Illustration 3 –
Hopper Lid Latches