Filter
Top Products
Page 12 12426-4-0104
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a Þ re or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the ß oor because
some gas is heavier than air and will settle on the
ß oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the Þ re
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it; call a qualiÞ ed
service technician. Force or attempted repair may
result in a Þ re or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualiÞ ed service techni-
cian to inspect the appliance and to replace any part
of the control system and any gas control which has
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power (if applicable) to
appliance if service is to be performed.
3. Remove control access panel (control door).
4. Push in gas control knob slightly and turn
clockwise to "OFF." Do not force.
5. Replace control access panel (control door).
7. Find pilot - follow metal tube
from gas control. The pilot is mounted
on front of main burner.
8. Turn gas control knob coun-
terclockwise
to "PILOT."
9. Push in control knob all the
way and hold in. Immediately light the pilot with a
match. Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release knob and
it will pop back up. Pilot should remain lit. If it goes
out, repeat steps 5 through 9.
• If knob does not pop up when released, stop and
immediately call a qualiÞ ed service technician or
gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
10. Turn gas control knob counterclockwise to
"ON."
11. Replace control access panel (control
door).
12. Turn on all electric power to the appliance
(if applicable).
13. Set thermostat to desired setting.
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance (if appli-
cable).
4. Remove control access panel (control door).
5. Push in gas control knob slight-
ly and turn clockwise to "OFF."
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas.
Then smell for gas, including near the ß oor. If you smell
gas, STOP! Follow "B" in the safety information above.
If you don't smell gas, go to the next step.
LIGHTING INSTRUCTIONS
GAS CONTROLKNOB SHOWNIN "OFF" POSITION
GAS CONTROL KNOB SHOWN IN "OFF" POSITION
LIGHTING INSTRUCTIONS