Filter
Top Products
31
Chapter 6 Glossary of Terms
Start Delay Uni-Tran Net Safety: power up delay in progress
Switch On: magnetic reed switch is activated or manual reset switch is
activated
Calibrate Sensor: mode for calibrating the unit
Auto Cal: automatic calibration mode
Sensor Fault: fault present, sensor or sensor wiring failure
2
(Not applicable to O sensor)
Zero Set: calibration zero gas setting in progress
2
(Not applicable to O sensor)
Apply 50% Span: apply 50% calibration gas
2
(Not applicable to O sensor)
Setting Span: span gas detected, automatic span gas setting in progress
2
(Not applicable to O sensor)
Remove Gas: remove calibration gas
Fail Cal. : calibration span setting failed
2
(Not applicable to O sensor)
Time Out: calibration failed, no gas detected during calibration
2
(Not applicable to O sensor)
Setting Zero: Setting zero level on controller
2
(Not applicable to O sensor)
Neg. Drift: excessive negative sensor drift
Set Relay Options: mode for setting the alarm relay
Review Relay Settings: mode for reviewing the alarm settings
Set Low: set low alarm level
Set High: set high alarm level
Coil Status: set the coil status for relays
Energized: relay is normally energized