Filter
Top Products
11
UL Model No.: CF144 & CF152
Setting Operating
Frequency of
Remote Control
1. Slide the five switch levers in the
remote control to your choice of ON
(up) or down positions. Use a ball-point
pen or small screwdriver and slide the
levers firmly up or down.
2. When power is restored, push and hold
the fan OFF button ( ) for 3 to 5
seconds to set the code in the receiver.
3. If airflow is desired in the opposite
direction, press the ( ) button on the
remote control. The fan must be
operating at any speed for the reverse
button to function. The blades will turn
in the opposite direction and reverse
the airflow.
4. To set the desired fan speed, press the
( ) button to decrease the speed and
the ( ) to increase the speed. The
LED display will light up to indicate the
new speed selected.
5. To turn the downlight on, press and
release the ( ) button. The light will
turn on at the light intensity previously
selected.
6. To vary the intensity of the light, hold
the ( ) button down until the desired
light intensity is reached, then release
the button.
7. The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
Your remote control has code switches
which must be set in one of 32 possible
code combinations (Figure 16). The five
levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows (Figure 18):
Figure 18
BP7407 44" & 52" Curva Sky 1/11/10 9:54 PM Page 11