Filter
Top Products
17
AIR CIRCULATION SYSTEM
In order to improve air circulation in the room where the wood stove is installed, certain options are available
for specific stove models.
Blower: A variable speed-control blower is available. Please note that there are two types of blowers
available, depending on the stove model you have. If the hole at the back of your stove
(where the blower needs to be hooked-up) has a round outlet, you will need blower
#AC05520. If there is a rectangular knock-off, you will need blower #AC02050.
Thermodisc: Available on most models, the thermodisc is a sensor that connects to the blower`s
electrical supply cord, and it will start the blower when the stove`s temperature reaches 120°
F (49
o
C) and cut off power when the stove cools down below 100° F (37
o
C). Information
regarding installation of the thermodisc is included with the device.
The blower system includes some particularities for specific stove models: For the Compak,
CS1200, Little Sawman, ML, Nordic and RC, an adaptor is required in order to install the
blower. That adaptor is included with the stove, when purchased.
BAFFLE BRICK INSTALLATION (SAWMAN STOVE ONLY)
- The Sawman C-Cast baffle is shipped with the stove. However, in order to avoid shipping damages,
it is not installed on the stove. You need to install it by following the instructions on the drawing
below.
- Please note that heating the stove without the C-Cast baffle can seriously damage the firebox and
will automatically nullify your warranty. The C-Cast baffle will eventually need to be replaced. How
long it will take depends on how often you use your stove. It is very important that you do not
postpone the replacement of the C-Cast baffle when you see that it starts to disintegrate.