Filter
Top Products
CONNECTING STOVE TO OIL TANK
• Make sure that the tank outlet is 12" (305 mm) higher than the inlet of the carburetor. (Gravity fed)
• Use only copper piping to connect tank to stove.
• Make sure that there is a small slope on the connection from the tank toward the stove.
• A 3" (75 mm) down slope is needed on the tank itself, from the outlet towards the other end of the
tank.
• When the tank is installed outdoors, it is preferable to use oil #1, to avoid viscosity problems.
NOTE : THE BAROMETRIC TANK SHALL BE LOCATED SO THAT THE TANK WILL NOT BE
EXPOSED TO THE DIRECT RAYS OF THE SUN OR BE ADJACENT TO ANY SOURCE
OF INTENSE HEAT.
Figure 11 : STOVE AND OIL TANK CONNECTION
Page 6 of 15