Filter
Top Products
LIGHTING (CONT’D)
• Place the flow regulating handle on the "1" position, as soon as the oil enters the burner
return to "0" position.
• Open the door and pore into the burner 2 to 3 once (75 ml) of lighting gel or wood
alcohol.
NOTE : USE OF LIGHTING GEL IS BETTER FOR A SAFE IGNITION.
• With a long wood match, ignite carefully and close the door.
• After a couple of minutes (before alcohol goes out) the burner and the chimney are hot,
place the flow regulator handle on "1" position.
Note : Do not leave matches or other materials in the burner in order to
keep it clean. It allows a better combustion.
IF YOU MISS THE STOVE’S LIGHTING, ALWAYS WAIT FOR THE
BURNER TO COOL DOWN TO ROOM TEMPERATURE BEFORE
USING BURNING ALCOHOL AGAIN.
IF, FURTHER TO SOME MISOPERATION, THE BURNER IS FILLED
WITH IMPORTANT QUANTITIES OF OIL, ALL OF THE OIL MUST
FIRST BE REMOVED BEFORE LIGHTING THE STOVE AGAIN.
CHANGING INTENSITY
• Always wait 10 minutes minimum before increasing the flow (between each position). This allows
flame to stabilize and avoid suiting up.
• No waiting is needed to decrease the flow.
Page 9 of 15