Filter
Top Products
Replacing fuse
1. Shut off the water purifier with the ON/OFF button.
2. Disconnect the power supply to the water purifier with
the safety switch in the central electrical unit.
3. Remove top cover by pressing the Release button at
the back of the purifier. Then unhook the top cover at
the front.
4. Carefully remove the fuse from the purifier using e.g. a
flat screwdriver, see fig. K.
5. Install a new fuse in the water purifier, see section
“Consumable parts”.
6. Refit the top cover.
7. Switch on the power supply to the water purifier with
the safety switch in the central electrical unit.
8. Start the purifier by pressing the ON/OFF button.
Store the water purifier
If the water purifier is not going to be used for an extended
period, it should be put into storage.
1. Empty the water purifier, see section ”Draining”.
2. Remove the filter. Let it drain for a few minutes and dis-
card it. (The filter can be discarded with ordinary house-
hold waste.)
3. Refit the filter cover and the cover for the purifier.
When the water purifier is going to be used again:
Install a new filter in the filter housing, see section “Replacing fil-
ter”, open the shut off valve on the inlet hose and flush the water
purifier for approx. 1 minute.
12
K
MAINTENANCE