Filter
Top Products
1. Adding More Water To Toilet Bowl
Push the “Add Water” switch until the desired
water level is attained. To prevent overflowing the
toilet, a timer inside the control module limits
the amount of water that can be added.
2. Flushing The Toilet
When the vacuum status panel’s green "OK to
Flush" light is on, and the red "Do Not Flush" light is
off, press the “Flush” switch for a moment then re-
lease it. Holding the switch down will not prolong
the flush cycle nor start a new flush cycle. The
switch must be allowed to return to the “off” posi-
tion and the vacuum must be allowed to recharge
before another flush cycle can be initiated.
A full holding tank will also prevent the toilet from
flushing.
The Water Level Settings and Mode Switch settings remain the same as 3000 series toilets (see page 4 of
owner’s manual).
OPERATING INSTRUCTIONS – 3100 SERIES VACUUM-DISCHARGE TOILET
WIRING DIAGRAM – 3100 VACUUM-DISCHARGE TOILET
REMOTE VACUUM FLUSH SWITCH
(3100 models)
Dometic Corporation • Sanitation Systems
13128 State Rt 226, PO Box 38
Big Prairie, OH 44611
60034xxxx 5/04