Filter
Top Products
16
XR10 Programming Guide
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
9.1 STOP
At the STOP prompt, pressing any SELECT key allows you to exit the XR10 Programmer.
When selected, the panel performs an internal reset and exits the programmer.
The Stop function causes the following to occur:
• The system is DISARMED
• The panel's Status List is CLEARED
During the Stop function, all keypad displays are momentarily blank for two seconds. Once
the programming function is terminated, the keypads return to the Status List display.
10.1 SET LOCKOUT CODE
Pressing COMMAND at the Stop prompt displays SET LOCKOUT CODE. This feature
allows you to program a special code that will then be required to gain access to the panel's
internal Programmer through the keypad.
Changing the Lockout Code
You can change this code at any time to any combination of numbers from 1 to 5 digits long
(1 to 65535).
1. Press a SELECT key. The display changes to ENTER CODE: -.
2. Enter a 1 to 5 digit code (do not enter a number higher than 65535). Press COMMAND.
3. Enter the new Lockout Code again. Press COMMAND. The keypad display changes to
CODE CHANGED.
Once you have changed the code, it is important that you write it down somewhere and store
it in a safe place. Lost lockout codes require the panel to be sent back into DMP for repair.
9 - STOP
SET LOCKOUT CODE
STOP
10 - SET LOCKOUT CODE
10 - SET LOCKOUT CODE