Filter
Top Products
12 www.dimplex.com
Operation
④ Replace the battery cover.
!
NOTE: When the “BAT”
symbol is present on
the remote control it is
recommended to replace
the batteries promptly, to
maintain full functionality of the
remote/replace. The remote
transmitter has a battery
backup time of only several
hours.
Initializing/
Reprogramming the
Remote Control
① Plug cord into 120 Volt wall
outlet.
② Ensure the Main On/Off
Switch located in the switch box
on the replace in the upper
right hand corner is in the
ON
position (Figure 4A).
③ Set the 3 Position Manual
Control (Figure 4B) to the
Remote position (left position).
④ Press and hold the
Initialization Button on the unit
(Figure 4C).
⑤ While holding the Initialization
Button, press the Flame/Heat
On/Off button on the remote
control transmitter.
⑥ Release the Initialization
Button on the unit.
⑦ Press the Flame/Heat On/Off
button to turn the Flame/Heat
function on.
Frequency Interference
If the replace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the circuit
board to eliminate interference.
① Simultaneously press the
“Temperature Down” button and
the “Flame Speed Down” button
on the remote control (Figure 6).
② “COD” will appear in place of
the sleep timer digits.
③ Release the “Temperature
Down” button and the “Flame
Speed Down” button.
④ Press the Initialization Button
on the unit (Figure 4C).