Filter
Top Products
www.desatech.com
113261-01A
8
WARNING: Never install the
heater
• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture,
clothing or other flammable
objects are less than 36 inches
(91.4 cm) from the front or top
of the heater or less than 10"
(25.4 cm) from sides of heater
• as a fireplace insert
• in high traffic areas
• in windy or drafty areas
CAUTION: If you install the
heater in a home garage
• heater pilot and burner must
be at least 18 inches (45.7 cm)
above floor
• locate heater where moving
vehicle will not hit it
CAUTION: This heater creates
warm air currents. These currents
move heat to wall surfaces next
to heater. Installing heater next
to vinyl or cloth wall coverings or
operating heater where impurities
(such as, but not limited to, to-
bacco smoke, aromatic candles,
cleaning fluids, oil or kerosene
lamps, etc.) in the air exist, may
discolor walls or cause odors.
IMPORTANT: Vent-free heaters add moisture to
the air. Although this is beneficial, installing heater
in rooms without enough ventilation air may cause
mildew to form from too much moisture. See Air
for Combustion and Ventilation, page 5. If high hu
-
midity is experienced, a dehumidifier may be used
to help lower the water vapor content in the air.
For convenience and efficiency, install heater
• where there is easy access for operation, inspec
-
tion and service
• in coldest part of room
INSTALLATION
Continued
An optional fan kit is available from your dealer.
See Accessories, page 22. If planning to use fan,
locate heater near an electrical outlet.
INSTALLING REMOTE CONTROL
RECEIVER
Remote control receiver must be installed to oper-
ate the remote control.
1. Locate receiver bracket, two packages of
AA batteries, remote receiver and screws in
hardware bag included with your heater.
2. Remove battery cover on receiver and install
batteries as shown in Figure 5. Replace battery
cover.
3. Insert wire connector and wire through bush
-
ing on the back of heater (see Figure 6).
4.
Lay heater onto its side. Insert wire connector
into valve at location shown in Figure 7 page 9.
Feed extra wire from receiver into heater base.
Place heater back in upright position.
5. Attach bracket around receiver with screws
as shown in Figure 6.
R
E
M
OT
E
OF
F
Battery Cover
Receiver
Figure 5 - Installing Batteries in Receiver
AA Batteries
R
EM
O
T
E
OF
F
Figure 6 - Installing Remote Receiver
Receiver
Receiver
Bracket
Wire
Connector
Bushing