Filter
Top Products
www.desatech.com
111251-01E30
CLEANING AND
MAINTENANCE
GLASS DOOR
-
-
Glass must be cleaned periodically. During start-
up it is normal for condensation to form on the
inside of the glass causing lint, dust, and other
airborne particles to cling to the glass surface.
During initial start-up a slight lm may form on
the glass due to paint curing. The glass should be
cleaned several times with a non-ammonia, non-
abrasive household cleaner and warm water after
the rst two weeks of operation. Thereafter, clean
the glass two or three times during each heating
season, depending on the usage and circumstances
present. Refer to Removing/Replacing Glass Door
on page 23 of this manual when removing glass
door for cleaning.
-
(see Replacement Parts
-
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
23). Vacuum all glass pieces with a shop vac.
CAUTION: Do not vacuum if
Use only the tempered glass door replacement
intended for this replace (see Replacement Parts,
page 38, for detail on ordering). No substitutions
may be made. See Removing/Replacing Glass Door,
page 23, for instructions for replacing glass door.
• Remove ember material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt, or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt, or lint.
LOGS
• If you remove logs for cleaning, refer to Install-
ing Logs, Lava Rock, and Glowing Embers,
page 24, to properly replace logs.
• Use a vacuum cleaner to remove any carbon
buildup on logs.
• Replace log(s) if broken. See Replacement
Parts on page 38.
• Replace ember material periodically as needed.
See Replacement Parts on page 38.