Filter
Top Products
www.desatech.com
111251-01E26
FIREPLACE
INSTALLATION
Continued
Ember Material
Figure 45 - Placing Ember Material on
Burner
8. Pull ember material apart into pieces no larger
than a dime. Place these pieces loosely and
sparingly directly onto exposed section of
front burner and along space between burner
and grate prongs (see Figure 45). This will
create glowing ember appearance as ame
touches ember material. Do not block air slots
by using too much ember material in one area.
It is not necessary to use all of ember material
provided.
9. Close glass door, lock door latches, replace
screen and close louvers (see Removing/Replac-
ing Glass Door, steps 5 through 7, page 23).
Figure 46 - Installing the WRC Remote
Receiver
Fireplace
Receptacle
Remote
Control
Receiver
Extension
Cord
Ignition Module
Plug
Figure 47 - Installing Battery into Back of
Handset
Pull to Remove
Insulation Tab
Battery Cover
12 Volt Battery
Back of
Handset
WALL SWITCH INSTALLATION
Installation of a wall switch allows you to activate
gas control valve and turn replace on and off. The
wall switch is to be connected to incoming 120 volt
regular household wiring that supplies electricity
to replace. Refer to wiring diagram, page 27.
OPTIONAL REMOTE CONTROL
Note: If using optional wireless hand-held remote
control, wall switch must be in ON position to be
operational. Remote control then becomes switch-
ing mechanism for replace operation.
1. Open lower louver panel of rebox.
2. WRC model receiver does not require a bat-
tery. Receiver can be installed by rst plugging
short extension cord into replace receptacle.
Plug receiver unit into extension cord. Finally
plug ignition module plug into receiver unit
(see Figure 46).
3. Activate remote handset battery by removing
insulating tab on back of handset (see Figure
47). Battery is included pre-installed.
4. Once battery is activated unit is ready to use.
5. Close lower louver panel.