Filter
Top Products
www.desatech.com
108860-01D 19
FIREPLACE INSTALLATION
Continued
-
securely in place. For replacement part information see
Replacement Parts, page 28.
glass is hot. Keep children and pets away from glass.
door or louvers.
Removing Louver Panels
Remove the top and bottom louver panels by simultaneously pulling
both top end spring latches towards the center of the appliance until
they are disengaged from the locating holes (see Figure 36). Repeat
for bottom spring latches and pull the louvers outward. To install or
replace items removed, simply reverse the procedures above.
Lock
Unlock
Figure 36 - Removing Louver Panel
Louver Panel
Glass
Frame
Assembly
Screw
Figure 37 - Removing/Replacing Glass Door
Spring Latch
Hinge
Removing Glass Door
If replacement of glass is necessary, the entire assembly, glass and
frame, must be replaced. If glass is broken, wear gloves and tape
the remaining fragments onto the frame.
1. Remove screen assembly by pushing the rod either left or right
and then down and forward to remove screen/rod assembly
from the rebox. Set assembly aside.
2. Lift up on latches to unlock. There are two on top of rebox and
two below rebox that hold glass door in place (see Figure 37).
3. While holding glass door to prevent it from falling and causing
injury, remove the ve screws from the hinge located on the
left side of door frame assembly (see Figure 37).
4. Remount the new frame at the hinge with ve new screws
before closing door. This will ensure seating of the gasket.
Latch
See Cleaning and Maintenance on page 25.
MODELS BL32D, BL36D(S), BL36DH(S)
This brick liner kit is optional. You may purchase brick liner from
your local retailer or see Accessories, page 29.
1. Remove top and bottom louvers to allow access to door
latches.
2. Unlock door latches and open glass door. See steps 1 and 2 of
Removing/Replacing Glass Door.
3. If installing brick liner in new replace, go to step 4. If install-
ing brick liner in an existing replace, carefully remove logs,
lava rock, and ember material.
4. Remove three screws from deector shield on the inside top
of rebox. Set shield and screws aside.
5.
Close glass door frame. Lock latches by placing the bar under the
tab on door and pushing down and back on latch (see Figure 37).
6. Replace screen/rod assembly by reversing step 1.
7. Replace louvers by reversing procedure under Removing Lou-
ver Panels.