Filter
Top Products
www.desatech.com
108860-01D 25
Use only the tempered glass door replacement intended for this
replace (see Replacement Parts, page 28 for detail on ordering).
No substitutions may be made. See Removing/Replacing Glass
Door, page 19 for instructions for replacing glass door.
PILOT AND BURNERS
• Remove ember material before cleaning burners and replace
when cleaning is complete.
• Burner and controls should be cleaned with compressed air to
remove dust, dirt, or lint.
• Use a vacuum cleaner or small, soft bristled brush to remove
excess dust, dirt, or lint.
LOGS
• If you remove logs for cleaning, refer to Installing Logs, Lava
Rock, and Glowing Embers, page 20, to properly replace logs.
• Use a vacuum cleaner to remove any carbon buildup on logs.
• Replace log(s) if broken. See Replacement Parts on page 28.
• Replace ember material periodically as needed. See Replacement
Parts on page 28.
VENTING SYSTEM
Conduct annual inspection of the venting system following these
guidelines:
1. Check areas of venting system that are exposed to the weather
for corrosion (rust spots or streaks and, in extreme cases, holes).
Have these items replaced immediately by a qualied service
person.
2. Remove the vent cap and shine a ashlight into the vent. Re-
move any foreign material.
3. Check for evidence of excessive condensation. Continuous
condensation can cause corrosion of caps, pipes, and ttings
and can be caused by having excessive lateral runs, too many
elbows, or exterior portions of the system being exposed to
cold weather.
4. Inspect joints to verify that no pipe section or tting has been
disturbed and loosened. Check mechanical supports such as
wall straps for rigidity.
CLEANING AND
MAINTENANCE
cleaning.
may need more frequent cleaning due to excessive lint
from carpeting, bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass door panel with care. Do
-
WARNING: Do not use abrasive cleaners as this
may damage glass. Use a nonabrasive household glass
cleaner to clean glass. Do not clean glass when hot.
Glass must be cleaned periodically. During start-up it is normal for
condensation to form on the inside of the glass causing lint, dust,
and other airborne particles to cling to the glass surface. During
initial start-up a slight lm may form on the glass due to paint cur-
ing. The glass should be cleaned several times with a non-ammonia,
nonabrasive household cleaner and warm water after the rst two
weeks of operation. Thereafter, clean the glass two or three times
during each heating season, depending on the usage and circum-
stances present. Refer to Removing/Replacing Glass Door on page
19 of this manual when removing glass door for cleaning.
WARNING: Only parts supplied by the manufacturer
glass door panel (see Replacement Parts, page 28).
This glass door panel is a complete unit. No substitute
materials may be used.
glass is hot. Keep children and pets away from glass.
If glass has been broken, carefully remove glass door (see Remov-
ing/Replacing Glass Door, page 19). Vacuum all glass pieces with
a shop vac.