Filter
Top Products
3
105647
OWNER’S MANUAL
For more information, visit www.desatech.com
PRODUCT
IDENTIFICATION
LOCAL CODES
Install and use fireplace insert with care.
Follow all local codes. In the absence of local
codes, use the latest edition of The National
Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
1. With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing.
Note:
The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
2. Locate two screws above top corners
of the fireplace insert screen. Remove
and discard these screws. Lift fireplace
insert screen up and pull out to remove.
3. Remove protective packaging applied
to logs, log base assembly, and fire-
place insert.
4. Remove fireplace insert hood from car-
ton insert.
5. Check all items for any shipping dam-
age. If damaged, promptly inform dealer
where you bought fireplace insert.
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this fire-
place insert:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, page 26.
Figure 1 - Log Base Assembly
Figure 2 - Fireplace Insert
Top Louver
Assembly
Firebox
Hood
Bottom Louver Assembly
Screen
Assembly
Top Outer
Casing
Firebox
Support
Blower
Assembly
Gas Line
Access
A
U
T
O
O
N
O
F
F
C
O
O
L
E
R
W
A
R
M
E
R
T
E
M
P
O
F
F
P
I
L
O
T
O
N
H
I
L
O
One Piece
Log Set
Remote Selector
Switch (Optional)
Piezo
Ignitor
Optional
Remote
Control
Control
Knobs
SAFETY
INFORMATION
Continued
12. Do not use fireplace insert if any part has
been exposed to or under water. Immedi-
ately call a qualified service technician to
inspect the fireplace insert and to replace
any part of the control system and any
gas control which has been under water.
13. Do not operate fireplace insert if any log
is broken. Do not operate fireplace insert
if a log is chipped (dime-sized or larger).
14. Turn fireplace insert off and let cool
before servicing. Only a qualified ser-
vice person should service and repair
fireplace insert.
15. Operating fireplace insert above eleva-
tions of 4,500 feet could cause pilot
outage.