Filter
Top Products
13
105647
OWNER’S MANUAL
For more information, visit www.desatech.com
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORIES
(GHRC and GHRCTA)
Installing Remote Receiver Unit
1. Disconnect switch wires from the con-
trol valve.
2. Remove screws attaching switchplate.
3. Remove switch plate (see Figure 25).
Discard after removing.
4. Install remote receiver unit onto gas log
heater base using mounting clips.
5. Push clips firmly into place (see Fig-
ure 26).
6. Connect wires as shown in Figure 27.
Figure 25 - Switch Plate and Wiring
Harness
Figure 28 - Installing Battery in Remote
Receiver
Screw
Switch Plate
Wires
Figure 26 - Installing Remote Receiver
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery.
Place battery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 29 - Installing Battery in Hand-
Held Remote Control Unit (GHRC Series)
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 27 - Connecting Wires
Red Wire From
Receiver
Valve
White Wire
From Receiver
INSTALLING 9-VOLT
BATTERIES
Two 9-volt batteries (not included) are re-
quired to operate this heater with the wire-
less hand-held remote control set. Install
one battery in the receiver and one in the
hand-held remote control unit.
Note:
Only
use alkaline batteries.
Installing 9-Volt Battery (Not
Included) in Receiver
1. Locate back of receiver under front
burner of heater.
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Remote Receiver
Mounting
Clips
Remote Switch
Bracket
Battery Clip
9-Volt Battery
Terminal Wires
Remote
Receiver
Ignitor
Figure 30 - Installing Battery in Hand-Held
Remote Control Unit (GHRCTA Series)
Remote
Control
Unit
Battery
Cover
9-Volt
Battery
Terminal
Wires