Filter
Top Products
17
101969
INSTALLING
Continued
Figure 18 - Removing Log Base Assembly From Fireplace
Continued
WARNING ICON G 001
CAUTION
Do not pick up log base assembly by burners. This
could damage burners. Only handle base by grates.
CONNECTING FIREPLACE TO GAS SUPPLY
Installation Items Needed
• 5/16" hex socket wrench or nut-driver
• Phillips screwdriver
• sealant (resistant to propane gas, not provided)
1. Remove fireplace screen. Remove two screws that hold fireplace screen in place
for shipping. These screws are located near top of screen. Discard screws. Lift
fireplace screen up and pull out to remove.
2. Remove access door from rear or side of fireplace. See Product Identification,
page 4, for access door locations.
3. Remove screws that attach log base assembly to fireplace (see Figure 18).
Carefully lift up log base assembly and remove from fireplace (see Figure 18).
Note:
If adding the G8000 brick liner accessory, install it now. Follow instructions
in G8000 accessory kit.
* Purchase the optional A.G.A. design-certified manual shutoff valve from your dealer.
See Accessories, page 32.
A.G.A. Design-Certified Manual Shutoff Valve
With 1/8" NPT Tap*
3" Minimum
From External Regulator
(11" W.C. to 14" W.C.
Pressure)
Approved
Flexible
Gas Line
Tee Joint
Pipe Nipple
Cap
Sediment
Trap
Figure 17 - Gas Connection