Filter
Top Products
5
099618
1. Remove all protective packaging that has been applied to heater for shipment
2. Remove heater from carton.
3. Check heater for any shipping damage. If damage is found, promptly inform
dealer where heater was purchased.
ASSEMBLY
PFA/PV 042B
These models are furnished with a nose cone guard. Nose cone guard and
mounting screws are found in the shipping carton.
ASSEMBLY
(For 35, 50, and 70
Models Only)
Tools Needed
• 5/16" Nut Driver or Wrench
1. Place nose cone guard on top of upper shell flange. Make sure nose cone guard
is on hot air outlet end of heater.
2. Insert screws through nose cone guard and upper shell flange.
3. Tighten screws firmly.
Nose Cone Guard
Screw
UNPACKING
Hot Air Outlet
Upper Shell
Flange
Figure 3 - Nose Cone Guard Assembly, 35/50/70 Models Only