MultiChoice
®
Valve Trim
Installation Instructions
Owners Manual
17 Series
Write purchased model number here.
Table of Contents:
Warranty ..................................................................................... Page 2
MultiChoice
®
Rough-In Installation Instructions .......................... Pages 3 - 6
17 Series Installation Instructions ............................................... Pages 7 - 9
.
Maintenance ............................................................................... Page 10
Cartridge Summary References ................................................. Page 10
To order replacement parts, visit www.deltafaucet.com
1
You May Need
T
E
F
L
O
N
9/17/15
76653 Rev. B
CAUTION: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION!–As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary Rotational Limit Stop or temperature
knob adjustments at the time of installation and
further adjustments may be necessary due to
seasonal water temperature change. YOU MUST
inform the owner/user of this requirement by
following the instructions. If you or the
owner/user are unsure how to properly make
these adjustments, please refer to page 9, and if
still uncertain, call us at 1-800-345-DELTA.
After installation and adjustment, you must afx
your name, company name and the date you
adjusted the Rotational Limit Stop or temperature
knob to the caution label provided and apply or
attach the label to the back side of the closest
cabinet door and the warning label to the water
heater. Leave this Instruction Sheet for the
owner’s/user’s reference.
WARNING: This pressure balanced or
thermostatic bath valve is designed
to minimize the effects of outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the
plumbing system, if the rotational limit stop
or temperature knob is not properly set or if
the hot water temperature is changed after the
settings are made or if the water inlet changes
due to seasonal changes.
WARNING: Do not install a shut-off device on
either outlet of this valve. When this type of
device shuts off the water ow, it can defeat
the ability of the valve to balance the hot and
cold water pressures.
17 Series 17 Series
17 Series
76653