DeLonghi PAC WE 110 Air Conditioner User Manual


 
8
Replace the cap correctly and close the tank, pu-
shingitinasfarasitwillgo.Thetankholehasa
meshltertopreventtheintroductionofforeign
matter.Ifnecessary,thisltercanbeunscrewed
and removed for cleaning under running water.
Thetankdoesnothavetobefulltousethe
water function, but the length of time the
appliance will operate in water mode will be
shorter.
Donotllabovetheleveloftheholetoavoid
thewateroverowing.Thetankhasnoover-
flow prevention system.
Replacing the limescale filter
Turn the appliance off and unplug it from the
outlet.
Makesurethereisnowaterintheapplianceby
emptying the tank and internal tray as described
inthesection:“Endofseasonoperations”.
Laytheapplianceonitsbackasshowningure
17.Restitonatowelorpieceofcardboardto
avoidscratchesordamage.Removethelterco-
verbyunscrewingthefourscrews(g.17).
Removethelterdelicatelyandloosenthetwo
ties, making sure the two hoses connecting the
lterdonotslipinsidetheappliance.Fitthenew
lter (g.19), following the same procedure
in reverse (g. 17-18). Thenotch on the lter
(see gure 16)indicates the correct direction.
Thenotchmustalwaysbetowardstheinsideof
theapplianceandpoint“A”mustbefacingup-
wards.
Water may leak out while replacing the
limescale filter. You should therefore perform
the operation in a suitable location.
After replacing the filter, wait at least an hour
before starting the machine again.
When the filter has been replaced, turn the
alarm off by pressing the ON/STAND-BY
button (15) for 10 seconds.
The appliance emits a beep.
1
2
13
14
15
16