DeLonghi PAC WE 110 Air Conditioner User Manual


  Open as PDF
of 21
 
7
PREPARING FOR OPERATION IN WA-
TER MODE
Once the appliance has been installed, it is ready
for use.
However,itsefciencycanbeenhancedbyope-
ratingitinDe’Longhi’spatentedwatermode.
Thewaterinthetankincreasesthecoolingpo-
werofyourPinguinoandatthesametimeredu-
ces noise levels and electrical consumption.
Compared to air, water reduces the temperature
ofthecoolingcircuitmuchmoreefciently,be-
fore being given off from the air exhaust hose in
the form of vapour.
Rememberthat:
• You mustalways usesalt-free cleanwater,
tap water is recommended.
• Thelengthoftimethewaterinthetanklasts
depends greatly on environmental conditions
such as temperature, humidity, insulation,
the sun exposure of the room, the number
of people present, etc. As an estimate, the
water lasts about six hours.
TheBOOSTfunction(seepage13)shortens
theoperatingtimetoabout4hours,butthe
coolingpowerandefciencyareincreased.
• When the water in the tank runs out, the
light comes on and operation of the
appliance switches automatically to air-air.
The appliance is fitted with a resin lime-
scale filter enabling normal tap water to be
used.
The resins reduce water hardness and therefo-
re prolong the working life of the appliance.
“CF” is displayed when the limescale fil-
ter needs replacing. The efficacy of the filter
depends on water hardness. It should, howe-
ver, be replaced every five years.
Setting water hardness
Measurewaterhardnessusingtheindicatorpa-
per provided.
• Remove the indicator paper from its pack
(R).
• Immerse the paper completely in a glass of
water for one second.
• Remove the paper from the water and sha-
ke lightly. After about a minute, 1, 2,3, 4
or 5 red squares appear, depending on the
hardnessofthewater.Theappliancecanbe
set to three different water hardness levels
soft(H1),medium(H2)andhard(H3).De-
termine the hardness of the water you will be
using by comparing the red squares on the
indicator paper with the table below.
Tosetwaterhardness,proceedasfollows:
1. Set the appliance to stand-by.
2. Hold the FAN button on the control panel
downfor10seconds.Theapplianceemitsa
beep and H1, H2 or H3 is displayed.
3. Usethe +or -buttons toset thehardness
level according to the table below. Wait a few
secondsforthesettingtobememorized.The
appliance emits another beep and goes back
to stand-by.
The machine is set by default for medium
hardness (H2).
Filling the tank
Thewatertankislocatedatthebottomoftheap-
pliance.PushinontheTankDoor(J)abovethe
wordPULL,andpullthetankoutasfarasitwill
go(g.13).Removethecapanduseacontainer
(bottle, jug, watering can) to pour in the water
(g. 14/15).Youcan seewhen thetank isfull
throughthellinghole.Itholdsamaximumof
21 pints (10 liters).
20
19
Soft
Water hardness indicator Level
H1
H2
H3
Medium
Hard
 previous next