Filter
Top Products
8 Drive Tray Assembly Conversion Instructions
Scroll using the arrow buttons to select the correct drive (drives are numbered 0
through 3 starting from the bottom).
A sub-menu allows you to set drives “on-bus” (the same SCSI bus asa the library or
“off-bus (a different bus). This is necessary for some host software packages. The
option is part of the Set Drive SCSI ID configuration routine.
The factory drive settings are below:
8. When finished with all the above settings, press MENU. If you have set or changed the
Drive Count the following message appears on the display:
New configuration requires mach reset. Push SYSTEM RESET
Push SYSTEM RESET at this time. The library re-initializes, after which the display
shows the following message:
ENTER Unlocks CAP
2—drive status
1—drive status
0—drive status
If not required to reset, press MENU until the above message appears on the operator
panel.
The library is now ready to use. Refer to the
PowerVault 130T User’s Guide
for instructions
on operating the library.
Drive 0 SCSI ID 1
Drive 1 SCSI ID 2