Filter
Top Products
10 11
How to disable Tamper Function (factory setting Tamper ON):
1. Key in the four digit user password code (factory default 1234.)
2. Press PROGRAM > 8 > ENTER
3. Press N (N = 0 without tamper function; 1 with tamper function). Press ENTER.
Quick guide: Press 1 2 3 4 > PROGRAM > 8 > ENTER > N > ENTER
HOW TO OPERATE THE AUTO DIALER
How to Arm the Alarm System/Turn the Dialer ON:
1. Check that the voice message and at least one phone number has been programmed
into the Auto Dialer.
2. Press 1 2 3 4 > ENTER or press the ‘ON’ button on the RF Keyfob. The Auto Dialer will
show ‘ON’ on the display.
3. The alarms will become active after the delay time you have set has expired.
Quick guide: Press 1 2 3 4 > ENTER or Press the ‘ON’ button on the RF Keyfob
How to disarm the Alarm System/Turn Dialer OFF:
To disarm the Alarm System or to stop the Dialer from dialing out after either the tamper
switch (if connected and active) or a alarm input has been activated, key in the four digit user
password code followed by ESC. Alternatively, press the ‘OFF’ button on the RF Keyfob. The
Auto Dialer will revert to the ‘OFF’ mode and must be re-set to the ‘ON’ mode as above.
Quick guide: Press 1 2 3 4 > ESC or Press the ‘OFF’ button on the keyfob
CAD-05 Kit Manual.indd 10 10/15/2009 9:40:53 AM