Filter
Top Products
Crestron CLS-C6 Series iLux
™
Integrated Lighting Systems
CLS -C6 Controls & Indicators
The table on the following page describes the function of the iLux unit’s controls and
indicators, which are listed in alphabetical order.
NOTE: Standard mode, Lights mode, and Shades mode mentioned in the following
discussions are described in “Operating Modes” on page 5.
CLS-C6 Controls & Indicators Descriptions
CONTROLS & INDICATORS DESCRIPTION
Bargraphs
In Standard mode and Lights mode, the bargraph
LEDs indicate the current light level for the six
lighting loads. In Shades mode, they indicate the
shade position for each of the shade groups.
Function Buttons
In Standard mode, these buttons are used to
select/recall scenes. In Lights mode, they are used
to make temporary adjustments to the six lighting
loads. In Shades mode they are used to make
temporary adjustments to the six shade groups.
IR Receiver
The IR receiver responds to commands from an
optional remote control.
Label Strip
The label strip identifies the use of the function
buttons. The illustration shows the default purpose:
selection of the first six scenes. The label in your
unit may be different, depending on the unit’s
configuration and lighting/shades arrangement.
Lights Pushbutton and LED
Use this button to select the Lights mode. The LED
illuminates accordingly.
Mini Phone Jack
This mini-phone jack is only to be used by your
dealer.
Motion Detector (CLS/CLSI-
C6M/C6MRF only)
In Standard mode, the motion detector recalls the
On scene if there is activity in the room, and
recalls the Off scene when there is no activity for
thirty minutes.
OFF Button
The OFF button always recalls the Off scene.
(Refer to “Standard Mode” on page 5.)
(Continued on following page)
User Guide - DOC. 6395B iLux
™
Integrated Lighting Systems: CLS-C6 Series • 3