Filter
Top Products
CertainTeed Vinyl Siding Installation Guide
138
Repeat until both sides of the sunburst are completed.
NOTE: To install the final panels at the top of the sunburst,
bow the panels slightly and slip them under the gable end
J-channel. For added protection against high wind, you
may have to face nail these panels.
Form a sleeve from aluminum coil stock and cover the center
J-channels. Secure it with pop rivets.
Cut into the lock anarched section from coil stock to form
the “sun” portion of the sunburst. Leave a 1" strip below the arch
and bend it out at a right angle. Fasten the piece in place using
pop rivets