Filter
Top Products
UNSTALLAT|OH STEP 10
Install The Protector System _
The safety reversing sensor must be connected
and aligned correctly before the garage door
opener wilt move in the down direction.
IMPORTANT INFORMATION ABOUTTHE SAFETY
REVERSING SENSOR
When properly connected and aligned, the sensor
will detect an obstacle in the path of its electronic
beam, The sending eye (with an amber indicator
tight) transmits an invisible light beam to the
receiving eye (with a green indicatorlight),, If an
obstruction breaks the light beam while the door is
closing, the door wilt stop and reverse to full open
position, and the opener tights will flash 10 times,
The units must be instafied insidethe garage so that
the sending and receiving eyes face each other
across the door, no more than 6" (15 cm) above the
floor, Either can be installed on the left or right of the
door as long as the sun never shines directly intothe
receiving eye Ions,
"Themounting brackets are designed to clip onto the
track of sectional garage doors without additional
hardware
Besurepoweris not connectedto thegaragedoor
openerBEFOREinstallingthe safetyreversingsensor
TopreventSERIOUSINJURYor DEATHfrom a closing
garagedoor:
, Correctlyconnectandalign thesafety reversing
sensor This requiredsafetydeviceMUSTNOTbe
disabled
• Installthesafetyreversingsensorso beamis NO
HIGHERthan6" (15 cm) abovegaragefloor
If it is necessary to mount the units on the walt, the
brackets must be securely fastened to a solid
surface such as the wall framing, Extension brackets
(see accessories) are available if needed If
installing in masonry construction, add a piece of
wood at each location to avoid drilling extra holes in
masonry if repositioning is necessary.
The invisible light beam path must be unobstructed
No part of the garage door (or door tracks, springs,
hinges, rollers or other hardware) may interrupt the
beam while the door is closing
Safer, Sensor
6" (15 cm) max above floor levistble Ugbt Beam
Protection Area
Facing the door from inside the garage
20