Filter
Top Products
INSTALLATllON STEP 6
Install the Door Control
Locate door control within sight of door, at a
minimum height of 5 feet (1.5 m) where small
children cannot reach, away from moving parts of
door and door hardware.
1 Strip 1/4" (6 mm) of insulation from one end of bell
wire and connect to the two terminal screws on
back of door control by color: white to 2 and
white/red to 1
2. Fasten the Door Control Button securely with
6ABxlol!2" screws If installing into drywall, drill
5/32" holes and use the anchors provided
3. Run bell wire up wall and across ceiling to motor
unit. Use insulated staples to secure wire in
several places.. Do not pierce wire with a staple,
creating a short or open circuit
4. Connect the bell wire to the terminal screws on the
motor unit panel: white to 2; white/red to 1.
5_Position the antenna wire as shown..
6. Use tacks or staples to permanently attach
entrapment warning label to wall near door control,
and manual release/safely reverse test labet in a
prominent location on inside of garage door.
NOTE: DO NOT connect power and operate opener
at this time. The trolley will travel to the furl open
position but will not return to the close position until
the sensor beam is connected and properly aligned..
WARNING
TopreventpossibleSERIOUSINJURYor DEATHfrom
electrocution:
• Besurepoweris not connectedBEFOREinstalling door
control
• ConnectONLYto 24VOLTlow vo]tagewires
Toprevent possibleSERIOUSINJURYor DEATHfrom a
closinggaragedoor:
oInstaI_doorcontrol within sight 0f garagedoor, out of
reachofchildren ata minimumheight of 5 feet
(15 m),and awayfrom all moving partsof door
• NEVERpermit ch[tdrento operateor playwith door
control pushbuttonsor remotecontrol transmitters
. Actiwte door ONLYwhenit canbeseenclearfy,is
properlyadjusted,andthereareno obstructionsto door
travel.
• ALWAYSkeepgaragedoor in sight until completely
closed NEVERpermit anyoneto cross pathofclosing
garagedoor.
Outside Keylock Accessory Connections
To opener terminal screws: white to 2; white/red
to I..
HARDWARE SHOWN ACTUAL SIZE
I_il 11tHIIfi I'tilii'i'liTil-_, l,_s,_lal_d
Lighted Deer Control Bulton Dqtwal_Anchors S|aples
Screws P',_4,..,_-I
(BACK V_EW)
DOOR CONTROL BUTTON
2..Conductor
Bell Wire
Opener
Terminal Screws
Back Paeel
of Opener
17