Filter
Top Products
20 21
OPERATION PART
/INDICATION PART
Operation Part/Indication Part
When using cold water
Press the cold button, and check if
the cold water mode lamp is on.
■
Press the cold button, check if the
cold water mode lamp is on, and
extract water.
Cold water button
Detects the ambient light,
reducing energy usage by
automatically decreasing the
operation frequency of the cooler.
Light detection sensor
7 8
To use hot water, press the hot button,
check if the hot water mode lamp goes
on, and extract water. (However, the
mode automatically returns to cold
water mode three seconds after hot
water has been extracted.)
Hot water button
To use room water, press the
room button and extract water.
Room water button
5
6
When using room water
Press the room button, and touch
the extraction part.
■
When using the hot water lock
Press the hot water lock for three
seconds. Check if the hot water lock
lamp comes on.
■
Light detection sensor setting function
Press the hot and cold buttons together for
three seconds; the hot water mode lamp
flickers as shown in the picture with a “pinging”
sound, and the system enters the setting
mode.
Press the cold button once; the cold water
mode lamp comes on, and the light detection
sensor function is set.
(When the cold water mode lamp goes out, the
function is disabled.)
After setting the mode, press the room button
for three seconds; the system saves the last
set mode and converts to standby mode.
■
To use hot water
Press the hot button, and check if the
hot water mode lamp is on.
■
To use both the hot water and cold water modes, press each button for more than three seconds. Once both hot water
and cold water mode lamp go on, you can use them.
“Light detection sensor” is set to disabled status at the initial usage
Fixed quantity extraction function
Press the hot and cold buttons together for
three seconds; the hot water mode lamp
flickers as shown in the picture with a “pinging”
sound, and the system enters the setting mode.
The quantity is adjusted each time the hot
button is pressed (120cc
200cc
300cc
120cc), and the hot water mode lamp goes on
according to each quantity phase. After
completing the mode setting,
press the room button for more than three
seconds; the system saves the last set mode
and converts to standby mode.
■
set unset
120cc 200cc 300cc
How to Use
Operation Part/Indication Part