Filter
Top Products
www.fmiproducts.com
124970-01A16
INSTALLATION
Continued
INSTALLING FIREPLACE HOOD
AND SCREEN
1. Attach hood to rebox using screws pro-
vided (see Figure 19).
2. Insert each rod through all rings located
at top of screen.
3. Insert rst rod into rear hole in left side
of rebox. Fasten rod to rear hole near
center of rebox using #10 x 3/8" Phillips
screw provided (see Figure 20).
4. Insert other rod into front hole on right
side of rebox and fasten using remaining
Phillips screw.
Figure 19 - Screw and Hood Placement
(Model May Vary From Illustration)
Figure 20 - Installing Fireplace Screen
(Model May Vary From Illustration)
Screw
Rear Hole
Top View of Rod Layout
Rod
Front
Hole
Ring
Screen
Identication
Label Location
Screws
Hood
REPLACEMENT PARTS
Note: Use only original replacement parts.
This will protect your warranty coverage for
parts replaced under warranty.
If your new product is missing a part or has
a broken component, please do not return it
to the store. Call FMI PRODUCTS, LLC at
1-866-328-4537 to answer questions and
replace parts under warranty.
When calling have ready:
• your name
• your address
• model and serial numbers of your heater
• how heater was malfunctioning
• purchase date
TEChNICAL SERVICE
You may have further questions about instal-
lation, operation, or troubleshooting. If so,
contact FMI PRODUCTS, LLC at 1-866-328-
4537.
When calling please have your model and se-
rial numbers of your heater ready.
You can also visit FMI PRODUCTS, LLC’s
web site at .