Filter
Top Products
Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-339
Cisco IOS Voice, Video, and Fax Configuration Guide
Step 9
Router(config-if)# h323 asr [bandwidth
max-bandwidth]
Enables ASR and specifies the maximum bandwidth
for a proxy.
The keywords and arguments are as follows:
• bandwidth max-bandwidth—Specifies the
maximum bandwidth on the interface. Value
ranges are from 1 to 10,000,000 kbps. If you do
not specify a value for the max-bandwidth
argument, the value defaults to the bandwidth on
the interface. If you specify the max-bandwidth
value as a value greater than the interface
bandwidth, the bandwidth will default to the
interface bandwidth.
Step 10
Router(config-if)# ip address ip-address mask
[secondary]
Sets up the ASR interface network number.
For an explanation of the keywords and arguments,
see Step 3 in this configuration task table.
Step 11
Router(config-if)# exit
Exits interface configuration mode and returns to
global configuration mode.
Step 12
Router(config)# interface type number [name-tag]
Enters interface configuration mode for a non-ASR
interface.
For an explanation of the keywords and arguments,
see Step 2 in the configuration task table in the
“Configuring a Proxy Without ASR” section on
page 333.
Step 13
Router(config-if)# ip address ip-address mask
[secondary]
Sets up a non-ASR interface network number.
For an explanation of the keywords and arguments,
see Step 3 in this configuration task table.
Step 14
Router(config-if)# exit
Exits interface configuration mode.
Step 15
Router(config)# router rip
Configures the Routing Information Protocol (RIP)
for a non-ASR interface.
Step 16
Router(config)# network network-number
Specifies a list of networks for the RIP routing
process or a loopback interface in an Interior
Gateway Routing Protocol (IGRP) domain. The
network-number argument specifies the IP address of
the directly connected networks.
Step 17
Router(config)# router igrp autonomous-system
Configures Interior IGRP for an ASR interface. The
autonomous-system argument specifies the
autonomous system number that identifies the routes
to the other IGRP routers. It is also used to tag the
routing information.
Step 18
Router(config)# network network-number
Specifies a list of networks for the Routing
Information Protocol (RIP) routing process. The
network-number argument should include an ASR
interface in an IGRP domain.
Step 19
Router(config)# network loopback-addr
Includes a loopback interface in an IGRP domain.
Command Purpose