Filter
Top Products
Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-332
Cisco IOS Voice, Video, and Fax Configuration Guide
Configuring a Forced Disconnect on a Gatekeeper
To force a disconnect on a gatekeeper, use the following command in privileged EXEC mode:
To force a particular call to be disconnected (as opposed to all active calls on the H.323 gateway), use
the local call identification number (CallID) to identify that specific call. Find the local CallID number
for a specific call by using the show gatekeeper calls command; the ID number is displayed in the
LocalCallID column.
Verifying a Forced Disconnect
To show the status of each ongoing call that a gatekeeper is aware of, use the show gatekeeper calls
command. If you have forced a disconnect either for a particular call or for all calls associated with a
particular H.323 gatekeeper, the system will not display information about those calls.
The following is sample output from the show gatekeeper calls command:
router# show gatekeeper calls
Total number of active calls =1
Gatekeeper Call Info
====================
LocalCallID Age (secs) BW
12-3339 94 768 (Kbps)
Endpt(s): Alias E.164Addr CallSignalAddr Port RASSignalAddr Port
src EP: epA 10.0.0.11 1720 10.0.0.11 1700
dst EP: epB2zoneB.com
src PX: pxA 10.0.0.1 1720 10.0.0.11 24999
dst PX: pxB 172.21.139.90 1720 172.21.139.90 24999
Configuring the Proxy
This section describes the following configuration tasks for configuring the proxy. Depending on your
specific network design, either the first task or the second task is required.
• Configuring a Proxy Without ASR, page 333
• Configuring a Proxy with ASR, page 337
Command Purpose
Router# clear h323 gatekeeper call
{all | local-callID local-callID}
Forces a disconnect on a specific call or on all calls currently
active on this gatekeeper.
The keywords and arguments are as follows:
• all—Forces all active calls currently associated with this
gatekeeper to be disconnected.
• local-callID—Forces a single active call associated with this
gatekeeper to be disconnected.
• local-callID—Specifies the local call identification number
(CallID) that identifies the call to be disconnected.