Filter
Top Products
Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-334
Cisco IOS Voice, Video, and Fax Configuration Guide
• :channel-group—Specifies a T1 channel group
number in the range 0 to 23 defined with the
channel-group controller configuration
command. On a dual port card, it is possible to
run channelized on one port and primary rate on
the other port.
Cisco MC3810 specifies the T1/E1 channel
group number in the range 0 to 23 defined with
the channel-group controller configuration
command.
• .subinterface-number—Specifies a subinterface
number in the range of 1 to 4,294,967,293. The
number that precedes the period (.) must match
the number to which this subinterface belongs.
• multipoint | point-to-point—(Optional)
Specifies a multipoint or point-to-point
subinterface. There is no default.
Step 3
Router(config-if)# h323 interface [port-number]
Selects an interface whose IP address will be used by
the proxy to register with the gatekeeper. The
port-number argument specifies the port number on
which the proxy will listen for incoming call setup
requests:
• The port-number range is from 1 to 65,356. The
default port number for the proxy is 11,720 in
-isx- or -jsx- Cisco IOS images.
• The default port number for the proxy is 1720 in
-ix- Cisco IOS images, which do not contain the
Voice over IP (VoIP) gateway.
Step 4
Router(config-if)# h323 h323-id h323-id
Configures the proxy name. (More than one name
may be configured if necessary.)
The h323-id argument specifies the name of the
proxy. It is recommended that this be a fully qualified
e-mail identification (ID), with the domain name
being the same as that of its gatekeeper.
Command Purpose