Filter
Top Products
Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-326
Cisco IOS Voice, Video, and Fax Configuration Guide
The following is an example of an RRQ notification sent from the gatekeeper to the server when the
above trigger condition matches:
REQUEST RRQ
Version-id:1
From:sj.xyz.com
To:Server-123
Notification-Only:
Content-Length:89
c=I:172.18.00.00:1720
r=I:172.20.01.40:16523
a=H:gw3-sj
t=voice-gateway
p=1# 2#
Configuring a Prefix to a Gatekeeper Zone List
To add a prefix to a gatekeeper zone list, use the following commands beginning in global configuration
mode:
Note Note that the zone prefix command matches a prefix to a gateway. It does not register the gateway.
The gateway must register with the gatekeeper before calls can be completed through that gateway.
Verifying an Added Prefix
To view the prefixes added to the gatekeeper zone list, use the show gatekeeper zone prefix command.
To see gatekeeper zone information, use the show gatekeeper zone status command.
Command Purpose
Step 1
Router(config)# gatekeeper
Enters gatekeeper configuration mode.
Step 2
Router(config-gk)# zone prefix gatekeeper-name
e164-prefix [blast | seq] [gw-priority priority
gw-alias [gw-alias, ...]]
Adds a prefix to the gatekeeper zone list.
For an explanation of the keywords and arguments,
see Step 3 of the configuration task table in the
“Starting a Gatekeeper” section on page 304.