Filter
Top Products
Model PNR™ Installation Instructions
8
Figure 8
Figure 9
ADJUSTMENTS
TENSION ADJUSTMENTS
Vertical Tilt Tension Adjustment
1. With display mounted, check for desired vertical tilt
tension.
2. Adjust the Centris Select
TM
knob until desired vertical tilt
tension is obtained. (See figure 10)
Figure 10
3. To lock the mount at the desired vertical tilt, tighten
the vertical tilt lock screw. (See figure 11)
Figure 11
Lateral Tilt Tension Adjustment
CAUTION: Overtightening lateral adjustment will
cause excessive wear and may distort adjustment
components.
1. Using a 9/16” wrench (not provided), slightly tighten or
loosen lateral tilt tension adjustment nut
(See figure 12).
2. Mount the display and check for desired tilt tension.
3. Repeat Steps 1 and 2 until desired tilt tension is
obtained.
Rotational Tilt Tension Adjustment
1. If necessary, loosen or tighten bottom rotational tilt
tension adjustment nut (See figure 12).
2. Mount the display and check for desired rotational tilt
tension.
3. Repeat Steps 1 and 2 until desired rotational tilt
tension is obtained.
Management Channel
Bottom Cable
Management Channel
Centris Select
TM
Adjustment Knob
Vertical Tilt
Lock Screw