Chicago Electric 94282 Vacuum Cleaner User Manual


 
SKU 94282 For technical questions, please call 1-800-444-3353 PAGE 11
The Dust Bag (108) is used only for dry vacuuming. To install the Dust Bag, insert
its opening over the portion of the Suction Port (13) protruding from within the Tank
(15) of the Vacuum Blower. Then, replace the Upper Cover (3) onto the Vacuum
Blower. (See Figure F.)
The Dry Filter (109) is used only for dry vacuuming. To install the Dry Filter, first
make sure that the foam filter is clean, dry, and in place over the filter basket. Then,
slide the Dry Filter over the Filter Basket (21). Then, replace the Upper Cover (3)
onto the Vacuum Blower. (See Figure F.)
SUCTION PORT
(13)
FOAM FILTER (107)
FILTER
BASKET
(21)
DUST BAG
(108)
DRY FILTER
(109)
FIGURE F
3.
4.
OPERATING INSTRUCTIONS
To Vacuum:
Connect the larger end of the Hose (110) to the Suction Port (13) of the Vacuum
Blower. Next, connect one or more Extension Wands (105) to the smaller end of
the Hose. Then, depending on the job at hand, connect the Crevice Tool (106) or
Floor Nozzle (104) to the Extension Wand. (See Figure G, page 13.)
NOTE:
Use the Extension Wands (105) to reach inaccessible spots and to eliminate
bending over to clean low areas.
Use the Crevice Tool (106) to vacuum hard-to-reach areas.
Use the Floor Nozzle (104) to vacuum upholstery, carpet, and floor mats of your
vehicle’s interior.
Make sure the Power Switch (2) of the Vacuum Blower is in its “OFF” position.
Plug the unit’s Power Cord (30) into the nearest 120 volt, grounded, electrical outlet.
(See Figure G, next page.)
Then turn the Power Switch (2) of the Vacuum Blower to its “ON” position to begin
vacuuming. (See Figure G.)
1.
2.
A.
B.
C.
3.
4.
5.