Filter
Top Products
Page 15SKU 93188 For technical questions, please call 1-800-444-3353
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE
PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF
HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Guide Wheel Replacement
Guide Wheels (44-9) due to excessive use may be damaged to a point of failure and
need replacement. Replace all three Guide Wheels at the same time.
Tangled Cable
If the Cable loops over itself in the Drum, it will not feed properly. With the motor stopped
and cord unplugged, remove and reload the Cable by hand to restore proper functioning. If
the Cable kinks, it is evidence of abuse and results from the use of too much pressure when
drain cleaning, or use of the wrong size Cable for the drain pipe being cleaned. Do not force
the Cable during use, let the cutter tool do the work.
Removing a Stuck Cable in the Drain Pipe
If the cable gets caught in the drain pipe move the Motor Direction Switch (5) to the Off 1.
position. Then, once the drum has stopped turning, move the Motor Direction Switch
(5) to the Reverse position to free the Cable.
If using the Power Cable Feed, putting the Motor in reverse will cause the feed Direc-2.
tion Lever (44-16) to operate opposite of normal.
Press the Foot Switch (14) while pulling on the Cable.3.
After the Cable is loose, move the Motor Direction Switch (5) back to the Forward posi-4.
tion.
Caution: Running the Motor in reverse for more than a few seconds at a time can
cause the Cable to tangle in the Drum.