Filter
Top Products
40
Remote Control
1 Press and release the Learn button on the garage
door opener. The Learn indicator light will glow
steadily for 30 seconds.
2 Within 30 seconds, press and hold
the button on the remote control.
3 Release the button when the
garage door opener light blinks.
It has learned the code. If light
bulbs are not installed, two
clicks will be heard.
Learn
Indicator
Light
Yellow
Learn
Button
To Erase the Memory
1 Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
ERASE ALL DEVICES
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2 Immediately press and hold the learn button again until the learn LED goes out. All codes
are now erased.
Reprogram any accessory you wish to use.
PROGRAM A REMOTE USING THE LEARN BUTTON
When replacing the light lens cover, ensure the antenna wires are hanging straight down.