Filter
Top Products
29
UP Button
Adjustment
Button
DOWN Button
PROGRAMMING BUTTONS
Adjustments
Tip: If anything interferes with the door’s upward travel it will stop. If anything interferes with the door’s downward travel, it will reverse.
Without a properly installed safety
reversal system, persons (particularly
small children) could be SERIOUSLY
INJURED or KILLED by a closing
garage door.
• Incorrect adjustment of garage door
travel limits will interfere with proper
operation of safety reversal system.
• After ANY adjustments are made,
the safety reversal system MUST
be tested. Door MUST reverse on
contact with 1-1/2" (3.8 cm) high
object (or 2x4 laid fl at) on fl oor.
To prevent damage to vehicles, be
sure fully open door provides adequate
clearance.
INTRODUCTION
Your garage door opener is designed with
electronic controls to make setup and
adjustments easy. The adjustments allow
you to program where the door will stop in
the open (UP) and close (DOWN) position.
The electronic controls sense the amount
of force required to open and close the
door. The force is adjusted automatically
when you program the travel and cannot be
changed.
PROGRAMMING BUTTONS
The programming buttons are located on the
left side panel of the garage door opener and
are used to program the travel.
UP (Open)
DOWN (Close)
CORRECT
INCORRECT
ONE-PIECE DOORS ONLY
When setting the UP travel for a one-piece
door ensure that the door does not slant
backwards when fully open (UP). If the
door is slanted backwards this will cause
unnecessary bucking and/or jerking when
the door is opening or closing.
To watch a short instructional video on
programming your new garage door opener
use your smartphone to read the QR Code
below: