Filter
Top Products
Installation Step 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type
as illustrated below and on page 27.
Make sure garage door is fully closed. Pull the manual release handle to disconnect the outer trolley
from the inner trolley. Slide the outer trolley back (away from the door) about 2" as shown in
Figures 1, 2 and 3.
Figure 2:
• Bring arm sections together. Find two pairs of holes
that line up and join sections. Select holes as far
apart as possible to increase door arm rigidity.
Ring
Fastener
Door
Bracket
Clevis Pin
Curved
Door Arm
Straight
Door Arm
Clevis
Pin
Inner Trolley
Outer Trolley
Lock
Washers
5/16"
Nuts
5/16"-18
Door Bracket
Screws
5/16"-18x7/8"
Manual
Release
Handle
Rope
Figure 3:
• If holes in curved arm are
above
holes in straight
arm, disconnect straight arm. Cut about 6" from
the solid end. Reconnect to trolley with
cut end
down
as shown.
• Bring arm sections together.
• Find two pairs of holes that line up and join with
screws, lock washers and nuts.
Lock
Washers
5/16"
Nuts
5/16"-18
Screws
5/16"-18x7/8"
Cut This End
Proceed to Adjustment Step 1, page 28. Trolley will re-engage automatically when the opener is operated.
26
Figure 1:
• Fasten straight door arm section to outer trolley
with a clevis pin. Secure the connection with a
ring fastener.
• Fasten curved section to the door bracket in the
same way as shown.
SECTIONAL Doors Only
Lock Washer 5/16"
Nut 5/16"-18
Ring Fastener
Hex Screw
5/16"- 18x7/8"
Clevis Pin
5/16"x1"
Hardware Shown Actual Size
Figure 1
Figure 2
Figure 3
Hole Alignment Alternative