Filter
Top Products
Manufactured under 1 or more of the following U.S. patents:
RE29,525; 4,037,201; 4,750,118; 4,806,930. Other Patents
Pending
CHILDREN OPERATING OR PLAYING
WITH A GARAGE DOOR OPENER CAN
INJURE THEMSELVES OR OTHERS.
THE GARAGE DOOR COULD CLOSE
AND CAUSE SERIOUS INJURY OR
DEATH. DO NOT ALLOW CHILDREN TO OPERATE
THE DOOR CONTROL(S) OR REMOTE CONTROL
TRANSMITTER(S).
A MOVING GARAGE DOOR COULD INJURE OR
KILL SOMEONE UNDER IT. ACTIVATE THE
OPENER ONLY WHEN YOU CAN SEE THE DOOR
CLEARLY, IT IS FREE OF OBSTRUCTIONS, AND IS
PROPERLY ADJUSTED.
Your garage door opener receiver and remote control transmitter has been set at the factory to a matching
code. The door will open when the button on the remote is pressed.
Below are instructions for programming any additional remotes you may purchase. See available accessories
on page 5.
23
Your "Smart" garage door opener will operate with
up to four "Smart" remote control transmitters, (with
green indicator lights) a Keyless Entry System and
code switch transmitters (with red indicator lights).
To Add A Remote
1. Press and hold the remote push button.
2. Then press and release the "Smart" button on the
back panel of the opener (Figure 2). The opener
light will flash once.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener light flashes, the opener has
not accepted the code.
To Change the Selected
Push Button On the Same Remote
If you purchase a multi-function remote control and
decide to use a different remote control button than
originally programmed into the opener, you need to
erase all the learned codes and reprogram each
remote used to operate the garage door opener.
To Erase All Remote Control Codes
• Press and hold the "Smart" code button on the
opener panel until the indicator light turns off
(about 6 seconds). All the codes the opener has
learned will be erased.
• Repeat Steps 1 and 2 for each remote control
in use.
Code programming instructions are also located
on the opener panel.
Figure 1
Figure 2
Code Programming Instructions
Push button
Garage Door Opener
(With Green "SMART" Button)
Green
"Smart"
Button
Indicator Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3