Filter
Top Products
35
10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
1. Install trim channels (left and right sides) by remov-
ing the two screws that hold the side brass trim and
put them back to hold both parts.
2. Slide on the trim top channel and fasten it from the
back side.
3. Remove the two screws that hold the top brass trim.
4. Install the two brackets to the studs in the bottom of
the top channel. Use the nuts supplied with the kit.
5. Reinstall the two screws to hold the top trim channel.
A flat louvre kit OR a bay window kit need
to be chosen to complete the installation.
IMPORTANT: Only Trim Panel Assemblies Approved by
Vermont Castings, Majestic Products Can Be Used on These
Products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information: Model
and serial number, part description with finish and part
number;
Key Description RHE42SSP RHE42LP
(1)
1 Frame Trim Kit
(Metallic Black) 10000931 -
2 Trim Top Channel 57508 -
3 Trim Side Channel 57509 -
4 Trim Top Channel - 57511
5 Trim Side Channel - 57507
6 Fasteners Package
(Not Shown) 54618 -
7 Trim Top Deflector 10000912 -
(1)LP trim to be used with SSP trim.
SSP trim dimensions are for openings smaller than
30³⁄₄" H x 42⁷⁄₈"W (781mm x 1089mm)
LP trim dimensions are for openings smaller than
33³⁄₁₆"H x 48"W (846mm x 1225mm)
C2 RHE42FP Trim
For use with RHEDV42
RHE42FP Flat face louvres with polished window
brass trim
Trim Assembly
1. Remove the front glass (see "Glass Frame Re-
moval" section).
2. Install top and bottom brass trim (Fig. 57 & Fig. 58)
Use the shortest black screw.
4. Install bottom decorative plate by simply sliding it
under the unit. No fastening is required for this
installation. (Fig. 59) Be sure to remove the protec-
tive plastic cover from the trim.
5. Install the bottom louvre assembly by fastening the
hinges with four screws to the pre-punched holes in
the cabinet.
6. Re-install the front glass.
7. Install the top louvre assembly by using the hooks to
hang it in place.
Trim Top
Trim Bottom
FP1290
Glass Frame
Screws
Fig. 57 Install top and bottom brass trim.
Louvre
NOTE: Position brass
trim top as shown (small
end up) to prevent heat
discoloration
Glass Frame
FP1291
Fig. 58 Position brass trim top with small end up.
3
2
3
1
5
5
4
7
RHE42SSP & RHE42LP Replacement Parts
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.