Filter
Top Products
10004758
BREF Electric Fireplace
16
Operating Instructions
For all other units.
The control compartment is located inside the fireplace
behind the steel curtain near the left front corner. To ac
-
cess the controls, simply slide the steel curtain open.
NOTE: The device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference re
-
ceived, including interference that may cause
undesired operation.
FP1451
control panel
1/04
Control Panel
1. ON/OFF Switch
2. Heater Control
FP1451
Fig. 13 Control panel.
1. ON/OFF Switch
The ON/OFF switch is for supplying power to light ef-
fects of the fireplace. This switch is normally illuminated
to indicate that there is electrical power to the unit.
2. Heater Control
The heater control acts to turn the heater ON and OFF,
as well as setting the comfort level in the room.
Turn the knob clockwise from the "OFF" position to
place the heater into operation. The further the knob is
rotated clockwise, the higher the set point temperature.
Turn the knob counterclockwise to lower the set point
temperature. Turn it all the way counterclockwise to turn
the heater function OFF.
3. Remote Control
If the unit is equipped with an on/off remote control, this
feature is to turn the flame effect on and off remotely
while the switch on the control panel is off. If the control
panel switch is on, this bypasses the remote control.
The receiver and transmitter is a matched-pair that
is pre-programmed and must be replaced together, if
necessary.