Filter
Top Products
17
Defiant Woodburning Stove
30001693
Set Up Your Stove
Cast iron stoves are heavy, and it will take two to four
people to move your Defiant into position.
Wipe the protective coating of oil from the griddle with a
clean dry rag or a paper towel.
Install the handle on the griddle. Slip the bolt through a
washer, a nylon bushing, then through the handle and
the other bushing, then through the steel spacer and
into the griddle tab. (Fig. 20) Tighten securely.
Assembly
Install Stove Legs
Remove and discard the four large slot-head screws
from the stove bottom. Install the stove legs (Fig. 21)
using the hex head bolts from the parts bag. Use 3/8”
washers with all four legs; the door handle holder
installs on the right front leg. Position the holder so the
hole to accept the handle hub faces out from the right
side of the stove. Tighten the bolts firmly.
CAUTION: Overtightening can strip tapped threads.
Storing the Handle
Use the removable handle to open or close the doors.
After using it, remove the handle so it will not get hot.
Store the handle in the handle holder installed behind
the right front leg. (Fig. 22)
Install the Optional Bottom Heat Shield
NOTE: The Bottom Heat Shield is required in most
installations. Refer to Floor Protection, Page 10, for
further details.
1. Remove the four 10-24 x 1/2” hex head bolts from
the corners of the ash drop on the stove bottom.
2. Screw the four 1¹⁄₄" spacers into the holes from
which you removed the bolts, finger-tight.
3. Align the bottom heat shield against the spacers with
the stepped side toward the rear of the stove.
4. Secure the shield with the four hex head bolts
removed from the stove bottom previously. Tighten
securely. (Fig. 23)
D
e
f
i
a
n
t
ST537
Attach
Bottom Heat
Shield
11/00
Spacers
ST537
Fig. 23 Attach the optional bottom heat shield.
ST466a
Madison
Attach legs
Leg Leveller
Leg Bolt
and
Washer
ST466a
Fig. 21 Attach the stove legs with leg levellers.
ST564
handle holder
12/13/00
Bottom Heat Shield
Door Handle Holder
Leg Bolt and Washer
ST564
Fig. 22 Handle holder and heat shield positions.
ST536
Fig. 20 Attach the griddle handle.
ST536
Attach
griddle handle
11/00
Bushings
Spacer
Knob
Washer
Bolt