Vermont Casting 1640 Stove User Manual


 
14
Intrepid 1640 Woodburning Stove
30000830
Stove in
Corner
Stove Installed
Parallel to Wall
Unprotected Surfaces
1. Shielding for a top exit stove must include the stove rear heat shield insert to protect the area behind the flue collar.
2. Chimney connector heat shields, in an installation that goes through a combustible ceiling, must extend to 1" (25mm) below the
ceiling heat shield, which is 22" (559mm) in diameter. The ceiling heat shield should be 24 gauge or heavier sheet metal, centered
on the chimney connector, and mounted on non-combustible spacers.
3. Rear Exit—horizontal connection from flue collar directly back through wall.
4. The ceiling heat shield required when chimney connector shields are used should meet the wall protector. This will require
trimming the ceiling shield along the line of intersection with the wall protector.
5. Requires the Flue Collar Shield Insert installed on the stove.
Protected Surfaces
Chimney Connector Clearance
Stove Clearance
(I) 12"
(305mm)
48" (1219mm)
Front Clearance to Combustibles
Side Rear Corners
(NA)
(NA)
(Q) 9"
(229mm)
(P) 12"
(305mm)
(J) 12"
(305mm)
(K) 9"
(229mm)
(L) 10"
(254mm)
(I) 12"
(305mm)
(H) 16"
(406mm)
(N) 14"
(356mm)
(H) 16"
(406mm)
(G) 24"
(610mm)
(M) 24"
(610mm)
(G) 24"
(610mm)
12" (305mm)
5" (127mm)
4
10" (254mm)
26 " (660mm)
*
*
12" (305mm)
Side Rear Corners
Stove Installed
Parallel to Wall
Stove in
Corner
Use the chart below together with the diagrams on the next page to determine the required clearance for your
particular installation.
Stove clearances are measured from the top plate to the combustible surface.
Chimney connector clearances are measured from the connector surface.
Intrepid 1640 Clearance Chart
Top Exit, Single-wall
Chimney Connector with
Connector Heat Shields
1, 2, 4
Rear Exit
3
Top Exit, Double-wall
Chimney Connector
5
Single-wall Chimney
Connector, without
Connector Heat Shields
Single-wall Chimney
Connector, with Connector
Heat Shields
Double-wall Connector
5
(D) 12"
(305mm)
(E) 16"
(406mm)
(F) 10"
(254mm)
(C) 20"
(508mm)
(B) 26"
(660mm)
(A) 22"
(559mm)
Top Exit, Single-wall
Chimney Connector
without Connector Shields