Filter
Top Products
20
OPERATION HOMESAFE® PROGRAM
OPERATION FANMINDER™ PROGRAM
To operate the Home-Safe Program:
1. Turn the power button off for at least 5 seconds.
2. Turn the on. Immediately press and hold the "3" button for 5 seconds.
A series of tones will be heard indicating the command has been
accepted.
Note: This program overrides all manual control of lights and fan.
3. The lights will automatically cycled on and off in a controlled sequence as
follows: ON 1 hour, OFF ½ hour, ON 2 hours, OFF 1 hour, ON ½ hour then
OFF 2 hours. This seven hour pattern will repeat continuously so that a
different pattern of lighting is seen each day of the week.
4. To cancel the Home-Safe Program, press the Button OFF for ve
seconds.
The Fan-Minder feature will add to your comfort when used in the bedroom. The program
reduces the speed of the fan each two-hour interval to compensate for cooling night air.
1. To operate the lights for Light Minder Program – Turn the power button off for
at least 5 seconds.
2. Turn the on. Immediately press and hold the "2" button for 5 seconds. A
series of tones will be heard indicating the command has been accepted. Once
the lights turn on, they will automatically turn off after 2 hours.
3. The fan will respond with three descending tones. A timer is now initiated and the fan
will reduce one speed for each two-hour interval. The fan will not, however, descend
below the rst or the lowest speed.
4. You may increase the fan speed by pressing and holding any of the fan speed buttons until the desired
speed is reached, then release it. The fan will again reduce one speed for each 2 hour interval.
5. To cancel the Fan-Minder Program, turn the OFF for 5 seconds.
The Light-Minder Program automatically turns OFF the fan mounted lights after two
hours.
To activate the Light-Minder Program:
1. Turn the power button off for at least 5 seconds.
2. Turn the on. Immediately press and hold the "1" button for 5 seconds. A
series of tones will be heard indicating the command has been accepted. Once
the lights turn on, they will automatically turn off after 2 hours.
3. Light operation still remains normal, if you leave the room and turn OFF the
lights, the lights will blink to indicate the Light Minder command has been
accepted. The lights will stay on for 2 hours and then begin to dim. After thirty
seconds have elapsed, the lights will turn completely off. In CFL Mode, the lights will not dim, but shut
off after 2 hours.
4. To cancel the Light Minder Program, press the power button and leave off for ve seconds.
LIGHTMINDER® PROGRAM
Light-Minder