Filter
Top Products
17
Direct - Touch
W-74
Wall Control
BLACK AND WHITE
STRIPED WIRE
2 RED WIRES
2 BLACK
WIRES
6. Remove the two remaining wires from the three-way
switch. Connect one black wire of these wires to the black
wire on the W-74 control. Secure the splice with a wire nut.
7. The remaining wire is to be connected to the red wire on
the W-74. Secure the splice with a wire nut. Note: Cut and
strip the red wire to remove the crimped connector.
8. Connect the green ground wire coming from the back of the
W-74 control to the ground wire in the switch box. Secure
the splice with a wire nut.
9. Check your work by using the wiring diagrams as shown in
Figures # 4 and #5 on this page.
10. Install the W-74 in the wall box with the two long screws
provided.
11. Install the wall plate with the two short color-matched
screws provided.
12. Installation of the second W-74 control is identical. Repeat
steps 1 through 7.
OPERATION POWER
The power button is normally left in the on position. Always turn the
power off during cleaning or servicing the fan and during thunderstorms. It is
also used to exit or enter additional programs.
The power button must be left on to retain a previously set fan speed or
light level.
OPERATION SPEED CONTROL
There are ve individual speed settings for the fan. Each speed is
indicated by the number on the controller and an audible tone for
each speed.
To select the desired fan speed:
Press the number on the controller corresponding to the speed
desired. 4 is high, 3 medium, 2 low, 1 ultra-low, and 0 is off.
OPERATION REVERSING AIRFLOW
The direction of airow can be changed from downward to upward
or from upward to downward.
To reverse the airow:
1. Make sure the fan is on and blades are turning.
2. Press the reverse button. You will hear a series of clicks from
the fan as it speeds up before coming to a stop and changing
direction.
Note: It is normal for the fan
to start in the "High" position
from "Off" before changing to
the selected speed.
W-74 OPERATION
Figure 5