Filter
Top Products
18
CHANGING FREQUENCY SETTING
You will only have to change the dip switch settings in the
remote if you are using more than one fan in the same
area and want to control them separately.
DIP SWITCHES
SET TO ‘111111’
(Factory Setting)
NOTE: DO NOT set dip switch setting in the remote
to ‘000000’, this may cause frequency interference
from other Casablanca Products. All fans leave the
factory set to
“111111”
DIP
SWITCHES
(Figure 1)
OPERATION CFL MODE
Note: The control with this fan has been shipped with CFL mode active.
Your fan has the ability to disable the dimming feature to allow the use of CFL bulbs.
To activate CFL mode:
1. Turn the fan off by pressing the power button.
2. Allow the fan to remain off for at least 5 seconds.
3. Press the power button again to restore power to the fan.
4. Immediately press and hold the "1" and "3" buttons for at least 5 seconds. The fans lights will go to 100%
brightness and the dimming function will be disabled.
To cancel CFL mode:
5. Turn the fan off by pressing the power button.
6. Allow the fan to remain off for at least 5 seconds.
7. Press the power button again to restore power to the fan.
8. Immediately press and hold the "2" and "4" buttons for at least 5 seconds. The fans lights will dim to
50% brightness and the dimming function will be enabled. Press and hold the light buttons until the
desired dimmer setting is reached.
Caution: CFL bulbs will not
function properly when
dimmed, which may result
in ickering or reduced bulb
life.
DIP SWITCHES
SET TO ‘000000’
To turn the lights off and on, press and release the button for less than
one second.
To dim the down light, Press and hold the button for more than 1 second.
The light will come on at the last brightness setting and increase in brightness
until full power is reached, then start dimming until the lowest setting is
reached. This cycle will repeat until you release the light button.
OPERATION LIGHTS
Down Light
Note: With CFL mode active, the lights will not dim.