Filter
Top Products
15
Deluxe D
NOTES:
1. Compressor and blower motor thermally protected internally.
2. All wiring to the unit must comply with NEC and local codes.
3. Transformer is wired to 460-v BLK/RED lead for 460-3-60 units. Trans-
former is energy limiting or may have circuit breaker.
4. FP1 thermistor provides low temperature protection for water. When
using antifreeze solutions, cut JW3 jumper.
5. Refer to microprocessor control, LON, thermostat installation instruc-
tions for wiring to the unit. Wire “N01” from LON to “Y1” Deluxe D when
motorized valve is not used. Thermostat wiring must be Class 1 and
voltage rating equal to or greater than unit supply voltage.
6. Factory cut JW4 jumper. Dry contact will be available between AL1 and
AL2.
7. Transformer secondary ground via green wire with yellow stripe from
“C” terminal to control box.
8. Blower motor is factory wired for medium and high speeds. For any
other combination of speeds, attach black wire to the higher of the two
desired speed taps at the motor, and attach the blue wire to the lower of
the two desired speed taps.
9. Blower motor is factory wired for high and low speeds. No other combi-
nation is available.
10. Optional LON wires. Only connect if LON connection is desired at the
wall sensor.
11. The 460-v units using an internal secondary pump will require a neutral
wire from the supply side in order to feed the accessory with 265-v.
Fig. 17 — 50PCH,PCV units with Deluxe D and LON Controller (460 V)
LEGEND
AL — Alarm Relay Contacts
BM — Blower Motor
BMC — Blower Motor Capacitor
BR — Blower Relay
CB — Circuit Breaker
CC — Compressor Contactor
CO — Sensor, Condensate Overflow
FP1 — Sensor, Low Temperature Protection, Water Coil
FP2 — Sensor, Low Temperature Protection, Air Coil
HP — High-Pressure Switch
HPWS — High-Pressure Water Switch
JW1 — Clippable Field Selection Jumper
LOC — Loss of Charge Pressure Switch
LON — Local Operating Network
MV — Motorized Valve
MVES — Motorized Valve End Switch
NEC — National Electrical Code
*Optional Wiring.
P1 — Field Wiring Terminal Block
RVS — Reversing Valve Solenoid
TRANS — Transformer
TXV — Thermostatic Expansion Valve
Field Line Voltage Wiring
Field Low Voltage Wiring
Printed Circuit Trace
Optional Wiring
Relay/Contactor Coil
Condensate Pan
Solenoid Coil
Temperature Switch
Thermistor
Ground
Wire Nut
Relay Contacts - N.C.
Relay Contacts - N.O.
Low Pressure Switch
High Pressure Switch
Splice Cap
Circuit Breaker
a50-8440